ROBONET allows you to control multiple electric actuators with one single communication port, the gateway unit. A user can choose either the field network or the serial communication port to send their commands to the controller of an actuator.
This tutorial shows a basic introduction of each ROBONET unit, setup, and use of the RC Software on the PC through serial communication port to program a position table for each ROBONET controller.
The PCON stepper motor controller boosts the performance of our RCP4 electric actuators supporting a high-output driver. The speed has been increased 1.5 times and can handle payload twice as much as our conventional models.
Field networks DeviceNet, CC-Link, PROFIBUS-DP, CompoNet, MECHATROLINK (I, II), EtherCAT and EtherNet/IP are supported.
The video Instruction for How to setup IAI ROBO Cylinder/Electric Actuator using our Quick Teach Controller.
Controller in this video: RCM-PST, Electric Actuator: ERC3
